Publicidad
STEP 4
STAP 4
4-1. Verwijder de 4 bouten van de brander.
4-1. Remove the 4 bolts from the burner.
STEP 4
4-2. Steek de gasslang door de paal.
4-2. Put the gas hose through into the post.
4-3. Bevestig de branderunit aan de paal met de 4 bouten.
4-1. Remove the 4 bolts from the burner.
4-3. Fix the burner unit to the post by the 4 bolts.
4-2. Put the gas hose through into the post.
4-3. Fix the burner unit to the post by the 4 bolts.
STAP 5
STEP 5
5-1. Controleer of de verbinding van de verticale paal
5-1. Check whether the connection of vertical post and burner are
STEP 5
en brander volgens de instructies is gemonteerd en
of alle bouten en moeren zijn aangedraaid.
assembled according to instructions, and all bolts and nuts are
5-1. Check whether the connection of vertical post and burner are
5-2. Plaats 3 stuks grote platte ringen op 3 reflectorafstandhouders.
tightened.
assembled according to instructions, and all bolts and nuts are
5-2. Put 3 pcs Large Flat Washers on 3
tightened.
5-2. Put 3 pcs Large Flat Washers on 3
STEP 6
STAP 6
STEP 6
Fasten the reflector with 3 pcs Large Flat Washers and 3 pcs Wing Nuts.
Bevestig de reflector met 3 stuks grote platte ringen
Fasten the reflector with 3 pcs Large Flat Washers and 3 pcs Wing Nuts.
en 3 stuks vleugelmoeren.
Reflector Spacers.
Reflector Spacers.
- 8 -
- 8 -
STAP 4
STEP 4
STEP 4
Bout
Bolt
Bolt
STAP 5
STEP 5
STEP 5
Reflector
Reflector Spacer
afstandhouder
Reflector Spacer
STAP 6
STEP 6
STEP 6
Vleugelmoer
Wing nut
Wing nut
Reflector
Reflector
Reflector
9
Publicidad
Capítulos
