Troubleshooting Tips - Cafe CDD420 Serie Manual Del Propietário

Troubleshooting Tips... Before you schedule service
Problem
Dishes and flatware
not clean
Cloudiness on
glassware
A white film on
glassware, dishware
and the interior
22
Possible Cause
Filters are clogged
Wash program unsuitable
for the load
Spray arm unable to rotate
Drawer overloaded/
incorrectly loaded
Filter plate/drain filter is
incorrectly inserted
Detergent put in the
wrong compartment of the
dispenser
Excess food not removed
from dinnerware prior to
loading
Spray arm holes are
blocked
Low inlet water temperature
Water pressure is
temporarily low
Air gap or disposer clogged
High drain loop or air gap
not installed
Improper rack loading
Poor performing detergent
Not enough detergent
Combination of soft water
and too much detergent
Low performing phosphate-
free detergent
Water temperature entering
the dishwasher exceeds
150°F
This problem is likely
caused by a low quality
phosphate-free dishwasher
detergent
What To Do
Clean filters. See the Care and Cleaning section.
See the Getting started section for a suitable wash
program. Soils were too heavily baked on and dishes
may need soaking.
Make sure the spray arm is mounted correctly and free
to rotate.
See the Loading section.
See the Care and Cleaning section.
Detergent must be placed in the large compartment.
See Detergent Dispensing in the Dispensing section.
Scrape all food scraps off dinnerware prior to loading.
Clean the spray arm. See the Care and Cleaning
section.
Make sure inlet water temperature is correct. See Check
the Water Temperature in the Getting started section).
Turn on the hot water faucet nearest the dishwasher, let
run until the water temperature stops rising. Then start
the dishwasher and turn off the faucet. This ensures the
entering water is hot.
Turn on a faucet. Is water coming out more slowly than usual?
If so, wait until pressure is normal before using your dishwasher.
Clean the air gap or flush the disposer.
Refer to the Installation Instructions for proper drain line
installation.
Make sure large dishware does not block the detergent
dispenser or the wash arms. See the Loading section.
Use high quality detergents such as
Platinum™ ActionPacs™ or
Automatic Dishwashing
Add detergent. See Detergent Dispensing in the
Dispensers section.
This is called etching and is permanent. To prevent this
from happening, use less detergent if you have soft
water. Wash glassware in the shortest cycle that will get
it clean.
See A white film on glassware, dishware and the
interior in this Troubleshooting Tips section.
This could be etching. Lower the water heater
temperature.
To remove the white film, run your dishes through a dishwasher
cycle with citric acid. Use a WD35X151 citric acid kit found
online. Otherwise, use high quality rinse agents such as Cascade
Platinum™ Dishwasher Cleaner or Finish
Cleaner found at your local grocery store.
Pour the citric acid in the detergent cup and close the cover.
Place the filmed but otherwise clean glassware and dishware
in the dishwasher. Leave silverware and other metal items
out of the dishwasher. Turn the dishwasher on and let it run
through a complete cycle without detergent. The glassware,
dishware, and dishwasher should come out film free.
Cascade
®
Finish Quantum
® ®
Detergent.
Dishwasher
®
49-4000255 Rev 0
®