Publicidad
M.-Nr. 05719362
Depending on the version, a number of one of the following tokens are included:
Included parts
No.
Mat. no.
Designation
01699370
WM 2 24 x 1.8 Miele token
00011729
WM 8 17 x 1.8 Miele token
00011726
WM 9 25.5 x 1.8 token
Depending on the version, a sticker for the control field is included:
Included parts
No.
Mat. no.
Designation
1
Sticker
For safety reasons, the connection cable must not exceed 2.5 m in length.
The "Miele Service Documentation (MSD)" service application is required when carrying out maintenance work
on the appliance
The safety instructions and warnings in the Miele Service Documentation (MSD) for the corresponding model must be
observed.
Work on the appliance must be carried out in accordance with the work instructions.
Drilling template
The underlay also serves as a drilling template for the 4 fixing holes.
NOTE
The holes for fixing are re-drilled depending on the washing machine or tumble dryer model.
A
Observe the machine-specific instructions for drilling the holes.
Drilling fixing holes
This part of the instructions only applies to the following models:
PW 5065, PW 6055, PW 6065, PW 6080, PT 5135 C, PT 5136, PT 7135 C, PT 7136, PT 7186
A
Place the supplied underlay on the machine lid and align it with the edges of the machine lid with W = 35 mm and
Z = 80 mm, see Fig. 1.
A
Drill 4 holes with Ø 6.5 mm.
A
Punch out the pre-punched hole for feeding through the cable on the rear panel of the machine.
Drilling fixing holes
This part of the instructions only applies to the following models:
T 5200, T 5250
Additional parts required
No.
Mat. no.
Designation
1
00090179
Label (sticker to cover the sequential-circuit hole in the control panel)
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
15 von 63
20.01.2022
Publicidad
