Publicidad
M.-Nr. 05719362
A
Place the supplied underlay on the machine lid and align it with the edges of the machine lid with W = 60.5 mm and
Z = 31 mm, see Fig. 2.
A
Drill 4 holes with Ø 6.5 mm, see Fig. 2.
A
Drill 1 hole with Ø 3 mm, see Fig. 2.
A
Drill 1 hole with Ø 30 mm, see Fig. 2.
A
Bridge sequential circuit contacts P3, P5 and P7.
A
Plug contact 9 to 13 and contact 17 to 21.
A
Withdraw contacts 25 and 31 and bridge with plug connections.
A
Remove sequential circuit surge (9), see Fig. 4.
A
Cover the drill holes in the control panel with stickers mat. no.: 00090179.
A
Use the Ø 30 mm (10) hole for the connection cable with cable strain relief, see Fig. 4.
Drilling fixing holes
This part of the instructions only applies to the following models:
T 6200, T 6250, T 6251
A
Place the supplied underlay on the machine lid and align it with the edges of the machine lid with W = 60.5 mm and
Z = 31 mm, see Fig. 2.
A
Drill holes with Ø 6.5 mm, see Fig. 2.
A
Drill hole with Ø 3 mm, see Fig. 2.
A
Drill hole with Ø 30 mm, see Fig. 2.
A
Use the Ø 30 mm (10) hole for the connection cable with cable strain relief, see Fig. 4.
Drilling fixing holes
This part of the instructions only applies to the following models:
PT 7251, PT 7331, PT 8251, PT 8251 COP, PT 8253, PT 8255, PT 8331, PT 8331 COP, PT 8333, PT 8335, PT 8257,
PT 8337
A
Place the supplied rubber underlay on the machine lid and line it up with the edges of the machine lid with X =
60.5 mm and Y = 31 mm, see Fig. 3.
A
Drill 4 holes with Ø 6.5 mm, see Fig. 3.
A
Punch out the pre-punched hole for feeding through the cable on the rear panel of the machine.
A
Use the pre-punched hole for the connection cable (12) with cable strain relief (11), see 5.
Drilling fixing holes
This part of the instructions only applies to the following models:
PW 6107, PW 6137, PW 6167, PW 6207
A
Place the supplied rubber underlay on the machine lid and line it up with the edges of the machine lid with X =
60.5 mm and Y = 31 mm, see 2.
A
Drill 4 holes with Ø 6.5 mm, see Fig. 2.
A
Punch out the pre-punched hole (1) for feeding through the cable on the top rear panel of the machine, see Fig. 6.
A
Use the pre-punched hole for the connection cable with cable strain relief.
Drilling fixing holes
This part of the instructions only applies to the following models:
PW 413, PW 418, PW 811, PW 814, PW 818
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
16 von 63
20.01.2022
Publicidad
