Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Precautions
Read and follow this manual completely, observing all instructions and safety directions. Otherwise, serious
•
injury and damage can occur. Think about your safety, and the safety of others, first.
Hold the product securely when the flight battery is plugged in, keep the rotor away from body parts and
•
clothing, even it isn't spinning, as it could be turned on by accident. Beware of hair becoming en-tangled in
the rotor.
Do not fly when it's too windy or you may lose control and crash, causing injury or damage. Never fly near
•
people, vehicles, train tracks, buildings, power lines, water, hard surfaces or trees. Never allow anyone to
attempt to catch the model while it's in flight or serious injury may result.
Adult supervision for flying and battery charging is recommended for pilots age 14 and younger.
•
Only use a battery charger that is compatible with the flight battery. Never leave the charger unattended while
•
charging. This will help prevent overcharging and make sure damage does not occur to the battery, charger or
any other property. While charging, place the battery on a heat-resistant surface. Do not lay it on carpet or up-
holstery while charging.
Never cut into the battery, charger, or aeroplane wires or serious injury may occur. Causing the battery to
•
"short out" (crossing negative and positive bare wires) can cause fire, serious injury and damage.
When you finish flying your product, always unplug the battery before you turn off the transmitter.
•
Never use the product on the same frequency as another RC model in your area. The frequency of the model
•
is shown on the frequency crystals.
Recommended Tools
These tools are not included with the product but are recommended for use whilst working with this product
Mini Philips Screwdriver
Charging the battery pack
Use the supplied charger to charge the supplied battery. Other products are available and if used, you must follow
the products instructions to avoid damage.
The charge time for the battery is 120 minutes.
1.
Plug the battery charger into an AC outlet. The LED on the charger should glow green.
2.
Plug the battery into the charger. The LED on the charger will turn red indicating charging is in progress.
3.
Charging is complete when the LED indicator glows green. As charging nears completion the battery will get
warm.
4.
Unplug the battery from the charger when finished.
Cautions
Use the charger with adult supervision. Do not use the charger near water or when wet.
•
Do not use the charger if the wire is frayed or worn. If the wire is frayed or worn a short circuit can cause a fire
•
or burns.
If your battery gets hot and exceeds 50 degrees C during charge it may be faulty and you should contact your
•
retailer
If the battery pack bulges or expands during charge or use it is faulty and you should contact your retailer.
•
Never leave your battery pack on charge unattended.
•
All manuals and user guides at all-guides.com
Mini flat head Screwdriver
3
Publicidad
Solución de problemas
