Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
pads, powdered cleaners, bleach or cleaners
containing bleach because these products
can scratch and weaken the paint finish.
Cleaning the Inside
To help prevent odors, leave an open box of
baking soda in the fresh food and freezer
compartments.
Door Sealing
If either door does not seal correctly, excess
frost will collect inside the refrigerator. Make
sure the doors seal correctly:
1. Close each door on a piece of paper that
is about the size and thickness of a dollar
bill.
2. Gently pull the paper. You should feel a
slight drag between the gasket and the
cabinet.
3. Do this on all four sides of the door.
4. If you do not feel a slight drag on the
paper, the door does not seal correctly
Have your dealer or a Furrion authorized
service center to correct the seal of the
door.
Remove/Reinstall the
Refrigerator
Your dealer or Furrion authorized service
center must do this procedure.
CAUTION: The rear of the refrigerator has
sharp edges and corners. To prevent cuts or
abrasions when working on the refrigerator,
be careful and wear cut resistant gloves.
1. Remove the AC power cord from the
receptacle.
2. Remove the plastic vents from the
mounting flanges of the refrigerator.
3. Remove the screws from the upper and
lower mounting flanges on the front of the
refrigerator.
All manuals and user guides at all-guides.com
4. Remove the refrigerator from the
opening.
Repeat steps 4 to 1 to reinstall the
refrigerator into the enclosure.
Refrigerator Storage
Before the refrigerator is stored for an
extended (seasonal) period of time.
● Defrost and clean the interior of the
refrigerator. See "Cleaning" section for
detail.
● Close the doors with the storage latch.
If the refrigerator is stored for an extended
period of time, before start up:
● Make sure there are no obstructions in
the vents, the ventilation air pathway, or
the flue area.
Replacement Parts
You may purchase replacement parts through
your local RV dealer or Furrion authorized
Service Center.
LED Lamp Replacement
The interior light is at the top of the fresh
food compartment. To replace a burned-out
bulb:
1. Unplug the refrigerator from its
receptacle.
2. Remove the LED lamp cover by pulling it
downward.
3. Unscrew the screws holding the LED
lamp after fully cooled down and replace
with a bulb in the same or lower wattage.
4. Install the cover.
14
Publicidad
Solución de problemas
