Team kalorik TKG RVC 1004 AB PB Manual De Instrucciones página 16

FREQUENTLY ASKED QUESTIONS
The robot cannot be
activated.
The remote control
does not work.
The robot stops
working suddenly.
You can't schedule
cleaning.
Suction power is
weak.
The robot can't be
charged.
Robot can't return to
the Charging Dock.
The rolling brush
doesn't rotate.
Robot movements or
travel path are
abnormal.
TKG RVC 1004 AB PB
• Make sure the main power switch is in the ON position.
• Make sure the battery is fully charged.
• Replace the batteries (2 AAA) in the remote control.
• Make sure the remote control is within range (16 ft/5 m) of
the robot
• If you still have trouble, turn off the main power switch
and then turn it back on.
• Replace the batteries in the remote control.
• Make sure the robot is turned on and fully charged.
• Check if robot is trapped or stuck on an obstacle.
• Check if the battery level is too low.
• If you still have trouble, turn off the main power switch,
wait for 2 seconds, and then turn it back on.
• Make sure the main power switch on the bottom of robot
is turned on.
• Make sure the time, time of day (AM/PM), and the
scheduled time have been set correctly.
• Check if robot's power is too low to start cleaning.
Check if any obstructions are blocking the suction inlet.
•
• Empty the dust bin.
• Clean the filters with the cleaning brush.
• Check if the filters are wet due to water or other liquid on
the floor.
• Air-dry the filters completely before use.
• Check if the indicator on the charging dock lights up. If
not, contact the service center to repair or replace the
charging dock.
• Dust off the charging contact pins with a dry cloth.
• Check if you can hear a beep when robot returns to the
charging dock. If not, contact the service center to repair
or replace the charging dock.
• Remove objects within 3 ft/1 m to the left and right side
and within 6 ft/2 m of the front of the charging base.
• When robot is in the vicinity of the charging dock, it will
return more quickly. However, if the charging dock is
located far away, the robot will need more time to return.
Please be patient as it works its way back.
• Clean the charging contact pins.
• Clean the rolling brush.
• Check if the rolling brush and brush guard have been
installed properly.
• Clean the sensors carefully with a dry cloth.
• Restart the robot by turning the power switch off and on.
16