iPower SUA12000ED Manual Del Propietário página 22

Select the Fuel Source (Propane/LPG)
1. Make certain the gasoline valve is fully closed
"OFF" (O) position.
OFF
2. Fully open the Propane/LPG cylinder knob.
3. Flip the fuel source switch on the side panel to the
propane/LPG position.
4a. Recoil Start (propane/LPG )
4a.1 Move the choke lever to the "START" position.
START
4a.2 PULL-TO-PRIME
Flip the engine switch to the "RUN"
Pull the starter cord 1-2 times to prime the
engine.
4a.3 Move the chock lever to the "RUN" position.
4a.4 PULL-TO-RUN
Pull the starter cord slowly until resistance is felt
and then pull rapidly to start the engine.
NOTE:
If the engine fails to start in 1-2 pulls with choke in
the "RUN" position,then move chock lever to
"START" and repeat the "PULL-TO-PRIME"and
"PULL-TO-RUN" steps.
4b. Electric Start (propane/LPG )
4b.1 Move the choke lever to the "START" position.
position.
4b.2 Flip and hold the switch on the "START"
position. Engine will crank and attempts to start.
When the engine starts, release the switch to the
"RUN"
Page 20
START
position.
1-2 Times
RUN