ARENDO 305640 Manual Del Usuario página 22

To remove any manufacturing residues, fill the water container once with cold wa-
ter up to the maximum mark before using it for the first time. Boil the water by
adjusting the temperature to 100°C using the "+" and "-" buttons. The configured
temperature flashes in the display. Then press the "Start" button at the top of the
handle to switch the appliance on. Then discard the water.
5. Usage
Press on the lid opener to open the tiltable lid. Fill the kettle with cold water and
press the lid down until it locks into place.
Note: A scale is provided on the outside behind the handle. Do not fill the con-
tainer above the maximum mark. The boiling water may spurt out if the kettle is
overfilled.
Place the kettle on the base plate. The ACTUAL temperature of the water in the
kettle is now shown on the LED display.
If the appliance is not used for 3 minutes, the display switches off automatical-
ly. The display can be reactivated by pressing any button or by simply lifting and
placing the kettle back on the base. Press the "+" and "-" buttons and select the
desired temperature. Press the "Start" button to start using the appliance (you
hear a short beep), which is indicated by the (heating) symbol shown in the display
above the temperature display. Once the water reaches the target temperature,
you hear the beep 3 times. The heating element switches off automatically and
the boiling process is stopped. The appliance can now be lifted and the water can
be used. If you want to stop the boiling process early on, you can press the "Start"
button at any time.
The kettle stops the heating process to carry out an intermediate measurement
before reaching the target temperature. Please wait until the boiling process is
completed. You will hear a beep at the end.
22
English