Clean The Pressure Roller; Clean The Printhead; Clean The Label Photocell - Valentin SPE II Guía De Referencia Rápida

SPE II

Clean the Pressure Roller

C

Clean the Printhead

Printing can cause accumulation of dirt at the printhead e.g. by colour particles of the transfer ribbon, and therefore it is
necessary to clean the printhead in regular periods depending on operating hours, environmental effects such as dust etc.
CAUTION!
Printhead can be damaged!

Do not use sharp or hard objects to clean the printhead.

Do not touch the protective glass layer of the printhead.
•
Open the cover of printing system.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove the labels and transfer ribbon.
•
Clean the printhead surface with a special cleaning pen or a cotton swab dipped in pure alcohol.
•
Before using the printing system, let the printhead dry for about two to three minutes.

Clean the Label Photocell

CAUTION!
Label photocell can be damaged!

Do not use sharp or hard objects or solvents to clean the label photocell.
A
84
A soiled pressure roller can lead to a reduced print quality and can
affect the transport of material.
•
•
•
•
•
B A
B
CAUTION!
Pressure roller can be damaged!

Do not use sharp or hard objects to clean
the pressure roller.
Open the cover of printing system.
Turn the lever (A) counter clockwise to lift up the printhead (B).
Remove the labels and transfer ribbon
Remove deposits with the roller cleaner and a soft cloth.
Turn the roller (C) manually step by step to clean the complete
roller (only possible when the printing system is switched off, as
otherwise the step motor is full of power and the roller is kept in
its position).
The label photocell can be soiled with paper dust. This may
affect the label scanning.
•
Open the cover of printing system.
•
Turn the lever counter clockwise to lift up the
printhead.
•
Remove the labels and transfer ribbon.
•
Blow out the photocell (A) with the compressed air
spray. You have strictly to observe the instructions
mentioned on the can.
•
Moisten a cleaning card (B) with printhead and roll
solvent to clean additionally the photocell inside.
•
Reload labels and transfer ribbon.
English