Parts Detail; Cushion Placement - Permobil M2 Manual De Instrucciones

Comfort Cushions - M2, ACTA-EMBRACE, Curve Operation Manual

PARTS DETAIL

Package contents: cushion, covering(s)*, operation manual
M2**
The serial number label is located on the
bottom of the cushion.
See the product specifications section in this
manual for information about cover materials.
To order replacement parts, contact the
equipment provider or Customer Support.

CUSHION PLACEMENT

WARNINGS:
- Risk of falling: The bottom of the Incontinence Liner is slippery; DO
NOT use the Incontinence Liner without a cover.
- The cushion must be used with compatible covering(s).
- Inspect the cover and the foam for damage, and replace if necessary.
- When possible, use the loop fasteners to further secure the cushion to
the seating surface.
1 Place the cushion inside the covering(s). See the next page.
2 Place the cushion on the seat.
3 Before sitting on the cushion, check the
orientation:
- Make sure that the non-skid bottom of the
cushion cover is facing down.
- Make sure that the contoured foam faces
up and the zipper is in the back.
- For Embrace and M2 cushions, the carrying
handle should be in the front.
4 The user should sit on the cushion, in their usual sitting position.
Make sure that the cushion is properly sized to the individual.
IMPORTANT! If using an ATI (Adjustable Technology Insert for
Positioning) with the M2 Cushion or the ACTA-EMBRACE Cushion, place
the ATI inside the cover and beneath the cushion (and beneath the
Incontinence Liner, if using). Refer to the ATI instructions for placement
and adjustment.
ACTA-EMBRACE**
*Coverings available:
- STRETCH-AIR available on all cushions.
- COMFORT-TEK available with Curve.
- Available as an accessory for M2 and ACTA-
EMBRACE: COMFORT-TEK, COMFORT-TEK with
Glidewear; STRETCH-AIR with Glidewear
- Incontinence Liner available as an accessory for all
cushions.
5
Curve Incontinence Liner
**Anti-thrust shown
Cushion with Cover:
Orientation
Zipper
in Back
Front