INSTALLATION - GT2 SLOT MOUNT ON ACTA-BACK OR VISCO BACK
Attaching GT2 Slot Mount Hardware to an Acta-Back or Visco Back Support.
1
Using the 4mm hex key, release the bolts (A) and the safety washers (B) from
the slot lock bracket (C).
2
With the flat face of the slot mount link (D) on the inside face of the back
support shell (E) and the bolts (F) facing up, align the slot lock bracket halves
with the slot on the back support shell (E). The threaded half of the slot
lock bracket (C) should be placed on the inside of the back support shell (E).
Order of installation: bolts (A), safety washers (B), slot lock bracket half with
through holes (C), back support shell (E), slot mount link (D), slot lock bracket
half with threaded holes (C).
3
Tighten the bolts (A) to secure, and replace the back support cover. Continue
to the "Adjustment and Use" section for final hardware adjustments and pad
positioning.
E
BodiLink Lateral Trunk Support Operation Manual
Swing-Away Hardware without Support Pad
D
F
12
C
D
B
A