Emptying The Filter - Kokido VOLTERA 25 Manual De Usuario

DO NOT use the pool vacuum without an intact filter cage in place.

Using your pool vacuum without an intact filter cage in place will VOID
your warranty.
DO NOT leave the pool vacuum in the water when it is not in use.

Ensure the charging cable is detached and the charging port is plugged

with the protective cap before the pool vacuum is deployed.
1) Bring your pool vacuum to the side of your pool / spa. Immerse the pool vacuum in
water and turn the power ON/OFF switch to the ON position to initiate operation.
CAUTION! Make sure the pool vacuum is always facing downwards when it is placed
into the pool. Otherwise; it may bend the pole connector and damage it during the
process.
2) To remove the pool vacuum from the pool / spa, lift the pool vacuum while pointing it
downwards for water to escape via both sides and the bottom of the pool vacuum.
CAUTION! Make sure the pool vacuum is always facing downwards when it is removed
from the pool. Otherwise, the pole connector may be bent and damage the pool vacuum
in the process.
3) Rinse the pool vacuum with fresh water after every use. DO NOT use any detergent.
EMPTYING THE FILTER / CLEANING THE FILTER SOCK
(Remark: Filter sock is not necessarily included with every model)
WARNING!
Using the pool vacuum without a filter cage in place will
VOID your warranty.
In order to maximize the cleaning efficiency, be sure to clean the filter sock /filter cage
before and after each use.
CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the
power source and detach the pool vacuum from the charging plug. Make sure the pool
vacuum is OFF
1. Place the pool vacuum on a stable surface.
2. Hold the pool vacuum and pry up the hood lever to the end to completely release the
side locks.
14