Teuco RA12 Instrucciones De Montaje página 15

•
TILING THE WALL
- Unscrew the check screw of the diverter protective cap.
- Remove the protective cap from over the deviator.
- Divide the two sections of the protective cap.
- Insert the rubber seal supplied into the diverter and the
top part of the protective cap, as illustrated in Figure 8.
- Fix the protective cap in place with the check screw.
- Tile the wall taking care to leave a circular area around
the diverter, the same width as the protective cap.
•
FITTING THE WALL PLATE
- Unscrew the check screw of the diverter protective cap.
- Remove the protective cap from over the deviator.
- Screw the shim onto the diverter, as illustrated in Figure
10.
- Fit the wall plate supplied over the diverter so that it is
flush with the tiles.
•
FITTING AND SECURING THE LEVER
- Place the adjustment lever on the diverter and turn it, as
illustrated in Figure 12, until it can go no further.
- Screw the adjustment lever into place with the grub screw
provided.
•
FINISHING THE SYSTEM
- Place the cap over the housing of the grub screw securing
the adjustment lever, as illustrated in Figure 13.
GB
15