Hooking Up - Sony WAHT-SA2 Manual De Instrucciones

Hooking Up

Connect the surround amplifier to your
S-AIR main unit.
Before installing, make sure to
remove the AC power cords
(mains leads) of all S-AIR
products from wall outlets
(mains).
1
Insert the wireless transceiver in
the slot on the rear of the
surround amplifier.
Note
• Do not touch the terminals of the
wireless transceiver.
• Match the direction of the V marks.
• Do not insert anything other than the
wireless transceiver into the EZW-RT10
slot.
Rear panel of the surround amplifier
0
- R T 1
E Z W
2
Insert the wireless transmitter in
the slot on the S-AIR main unit.
For details, refer to the operating
instructions of the S-AIR main unit.
The illustration of the rear panel of an
S-AIR main unit is an example. Not all
S-AIR main units look exactly the
same.
Rear panel of the S-AIR main unit
5
GB