Publicidad
Idiomas disponibles
Idiomas disponibles
REPlAcINg thE WIcK
13
13
Fit the wick carrier to the wick. Make sure that the
rack of the wick carrier is on the same side as the
cog wheel of the burner.
14
Pull the cog wheel handle outwards.
15
Pull the wick and wick carrier towards the cog wheel.
15
16
When the wick carrier touches the wheel, turn the
16
cog wheel shaft anti-clock-wise.
17
Press the outer wick tube back into the burner and
turn it clockwise.
18
Check that the wick can move up and down easily.
19
Remove paper tails if any.
!
If the wick gets stuck in the burner, do not
force the cog wheel shaft as this may damage
the wick carrier. Repeat the above procedure
instead.
KoSMoS bURneR
1
Remove the tank.
2
Remove the lamp glass with insert.
3
lift the burner from the tank.
4
Turn the wick downwards and pull it out.
4
5
Unpack a new, dry and clean wick.
6
Insert the new wick, red end first, at the bottom
6
of the burner.
7
Push the wick in until it reaches the cog wheel.
4
www.sibir.com
13
8
Turn the cog wheel shaft clockwise until the wick end
8
comes out at the burner top.
9
Pull the wick back and forth through the burner a few
9
times.
10
Turn the wick until it is 2–3 mm (0.08-0.12") above the top
10
of the wick guide.
6
2–3 mm
16
8
10
16
15
9
copyright © sibir international
Publicidad
