Descargar Imprimir esta página

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 67
Note:
GB
• If no button is pressed within 10 seconds. The newly set
temperature will be stored.
• The temperature setting range from 2°C to 6°C (233610
v.02, 233627 v.02, 233634 v.02, 233641 v.02, 233658 v.02,
233665 v.02, 233269 v.02, 233238 v.02) ; The temperature
setting range from 2°C to 8°C (233696, 233290).
• Keep the door open time as short as possible in order to
keep a cool temperature inside.
2). Illumination inside the cabinet
• Press (9) to switch ON the light. Press (9) again to switch
OFF the light.
3). Refrigerant LED indicator
• During the cooling operation (compressor enabled), this
refrigerant LED (12) indicator will lights up constantly.
• After the inside cabinet reach the set temperature, the
refrigerant LED (12) indicator will flashes continuously.
• When defrost start, the refrigerant LED (12) indicator
light off.
4). Defrost LED indicator
• During the defrost operation, this defrost LED (13) indi-
cator will lights up constantly.
• After the defrost operation, defrost LED (13) indicator
will lights off.
Cleaning & maintenance
ATTENTION! Always disconnect the appliance from the elec-
trical mains and cool down before storage, cleaning & main-
tenance.
Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed from
the appliance. If the appliance is not cleaned properly, it will
reduce its lifespan and may result in a dangerous condition
during use.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• No parts are dishwasher safe.
10
Parts
How to clean
All accessories
• Soak in warm,
such as racks, rack
soapy water for
holders, etc.
about 10 to 20
minutes.
• Rinse under
running water
thoroughly.
External glass
• Wipe clean with
surfaces
a soft cloth and
a little neutral
detergent. Make
sure no water or
moisture enters
inside the of the
appliance.
Interior glass
• Remove any food
surfaces
deposits.
• Wipe clean with
Glass door
a soft cloth and
a little mild
detergent. Make
sure no water or
moisture enters
inside the of the
appliance.
Maintenance
• Check the operation of the appliance regularly to prevent
problems that can cause serious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Replacing the defective light
• ATTENTION! Always unplug the appliance from the electrical
power outlet before replacement.
• Remove both screws on the side of the light cover
• Remove the old light and replace with a new one of the same
type (not included). [Fluorescent tube 220-240V~ /50Hz 11W]
• Reassembly the light cover.
• If you do not sure how to replace, contact the supplier/ service
provider (See ==> Warranty).
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
• Special care must be taken when moving or transporting the
machine due to its heavy weight. With at least 2 persons or
using a cart. Move the machine slowly, carefully, and never
incline more than 5°.
Remark
Dry all parts well
at last.

Publicidad

loading