How To Install The Appliance - Luisi Air SANREMO Instrucciones De Uso Y De Montaje

HOW TO INSTALL THE
COOKER HOOD
1. Before carrying out the appliance installation,
please check that all components are not dama-
ged, in such a case contact your retailer and do
not carry out any installation operation
● Use an air exhausting duct whose maximum
length does not exceed 5 meters
● Limit the number of elbows in the ducting, sin-
ce each elbow reduces the air capacity of 1 linear
meter. (Ex. : if you use no. 2 x 90 ° elbows, the
length of piping should not exceed 3 meters).
● Avoid abrupt direction changes.
● Use a 150 mm. constant diameter or a simi-
lar section duct for the whole length.
● Use a duct approved by relevant standards in
force. The manufacturer shall not be held liable
for air capacity or noise problems due to non-
observance of aforementioned instructions and
no warranty will be provided in such a case.
2. Place the upturned hob (PAG.13 PART. 1) on
a suitable surface , making sure the glass is pro-
tected from scratches.
Take the 'filtering chamber 'out of the packaging
and install it as shown in fig. 1.
The 'filtering chamber' metal hooks shall be in-
serted in their suitable slots found on the hob
rear side, as shown in fig. 2.
After fitting the 'filtering chamber' to the hob, fa-
sten it using the metric screw provided with the
appliance, which shall be installed as shown in
fig. 3.
Fit the hob into the cabinet, as shown in the rela-
ted use instructions, included in the packing of
the induction hob.
Take the ventilation/fan unit out of the packaging,
fix the metal joint on it using the screws provided
with the appliance, as shown in fig. 4.
After installing the hob, place the ventilation/fan unit
immediately under the hob, as shown in fig. 5.
SANREMO
EN
In order to install the ventilation/fan unit in such a
way as it can touch the floor , make a 410mm X
410mm opening in the cabinet bottom side (see
fig.13).
Then place the two metal telescopic conduits into
the ventilation unit air inlet (figure 6), and fix them
using the screws supplied with appliance.
Lift the internal metal conduit until it reaches the
'filtering chamber' and fix it using the screws sup-
plied with appliance (fig. 7).
Seal the air flow opening with the adhesive tape
provided with the appliance, as shown in figure 8.
Connect the ducting to the ventilation unit. You
can use the air outlet on the right or left side of
the ventilation unit, according to the needs of the
kitchen: remove the four screws fixing the outlet
flange and replace it with the metal lid placed on
the opposite side.
The air outlet which is not going to be used must
always be covered and closed with the metal lid.
Another two plastic flanges are provided with the
appliance to connect different section ducts.
Flanges provided have the following sections :
230x80 mm
220x90mm
218x55mm (recommended for filtering mode in-
stallation only).
Fit the two grease filters into their housing , by
passing them through the hob central opening,
see fig. 9.
Fit the metal grid in order to close the hob central
opening, as shown in fig. 10.
Place the wiring box near the appliance, in order
to connect the flat cable to the corresponding flat
cable of the touch - control panel.
Connect the ventilation/fan unit cable to the ter-
minal block found inside the plastic black box,
see fig. 11B.
17