Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
Changing the Oil - TRP 40G and TRP 400G
The first oil change must be conducted in the first 5
hours of motor use. To change the oil, proceed as
follows:
1. Place the crusher on a leveled and flat surface.
2. Hot oil will drain better.
3. Collect used oil in proper container and wear
appropriate glasses and globes during the oil
change.
4. Open the oil drainage plug (1) so as to drain the oil
from the engine. Remove the oil inspection cap (2)
to facilitate the drainage of all the motor oil.
Attention!
If
motor
changing
oil,
to remove oil container. Hot oil is
released with more pressure, and may
cause burns.
Do not place oil containers or
discarded motor oil into common
waste bins or on the soil, follow the oil
manufacturer's instruction to correctly
discard it.
5. When oil has been fully drained, screw back oil
container (1).
Air Filter - TRP 40G and TR 400G
Warning!
All maintenance and cleaning should be
made with the equipment switched off and
the spark plug wire disconnected.
The air filter shall be always clean for the engine to
work perfectly.
is
hot
when
be
careful
6. Remove the cap (2) and add the required amount
of oil and, then, close the cap (2).
7. Check the oil level with the inspection cap (2).
For a precise reading, with the motor leveled,
check if the oil reached the bottom of the thread
where the inspection cap is threaded, this is the
correct level.
1
Image for illustration purposes only
Note:
Frequently check level of motor oil to
prevent damage due to lack of oil.
Blocking of the filter due to lack of cleaning causes
serious operating problems for the engine, among
them loss of power, and damage to the cylinder,
piston and piston rings.
Air filter - foam
Dip and tighten (do not twist) it in a solution of
neutral detergent water, removing all the dirt.
Dry it, rolling and pressing it in a dry cloth (do not
twist it).
2
53
Publicidad
Tabla de contenido
