Publicidad
Idiomas disponibles
Idiomas disponibles
–
Spray the water solution on your hands and ensure that no fin-
gerprints are left on the protective film during assembly.
501673-01
–
Remove the "Front" layer from the protective film and spray
the water solution onto the exposed adhesive layer.
501674-01
–
Align the protective film in the center of the display. The water
solution allows the protective film to be moved until it is in the
right position.
Info
A small distance remains from the edge of the display
to prevent it from becoming detached. Align the protec-
tive film in the center of the display.
501678-01
–
Wrap cleaning cloth
carefully push out the water and air pockets. Gently smooth
from the inside to the outside to remove as much water and air
as possible.
Info
Pay close attention to the edges of the protective film
to ensure that no water is trapped. This may result in
the protective film detaching from the display.
501675-01
–
However, if folds or water do gather at the edges, the material
can be warmed up with a hot-air dryer (low heat) and pressed
out with the squeegee
Info
When using a hot-air dryer, maintain a distance and
select a temperature that does not damage the protec-
tive film or the display. Set the temperature to modera-
tely warm only.
501676-01
2
3
around squeegee
(included) and
3
.
ASSEMBLY 5
9
Publicidad
