Programming With The Easy Base Unit - Gewiss Chorus GW 90 834 Manual De Instrucciones

PROGRAMMING WITH THE EASY BASE UNIT

All manuals and user guides at all-guides.com
Programming the inputs through the Easy base unit (code GW 90 831).
Each input to be programmed can be selected, at choice:
• by pressing the button or switch connected to the input: the corresponding channel will
be highlighted in the channel list in the "Application → New function" or "Application
→ Edit function" menu;
• directly from the list of channels of the "Application → New function" or "Application
→ Edit function" menus.
The functions can be created after the devices have been selected.
Names of the functions on the Easy base unit
button
edges
timer mode
scene
priority control
dimming pushbutton
dimming
blinds pushbutton
blinds
wind sensor
rain sensor
heating mode
heating On/Off
Refer to the Easy base unit documentation for further information on the programming
procedures.
After creating the desired function, it is possible to configure the device function
parameters from the "Application -> Parameters" menu.
The parameters available, in relation to the function created, are listed in the following
table.
The underlined value is the default value.
toggle
edge management command
command ON with timer
(the time is set on the actuator)
scene management command
send priority controls
dimming pushbutton management command
dimming management command
blinds pushbutton management command
blinds management command
wind alarm management command
rain alarm management command
thermal regulation commands (mode)
thermal regulation commands (enable/disable)
Configuration parameters (Easy)
23
E
N
G
L
I
S
H