DWT EX03-125 D Manual Original página 21

Symbol
power tool designation
Rotary sander is designed for the dry sanding of differ-
ent materials and surfaces�
[EX03-125 DV]
This model allows to polish by using special polishing
accessories and polishing substances�
Power tool
components
1
Auxiliary handle
2 Wing nut
3 Ventilation slots
4 On / off switch
5 Port for dust removal
6 Sanding plate (velcro-type)
7 Sanding sheet (velcro-type) *
8 Dust bag (assembly) *
9 Oscillation rate regulator
10 Lock-on button
11 Polishing sponge *
12 Polishing bonnet *
13 Body made of plastics *
14 Textile dust bag *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation
of power tool elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Meaning
Attention� Important�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Useful information�
During operation, remove
the accumulated dust�
Do not dispose of the power
tool in a domestic waste
container�
DWT
Автотовары «130»
Do not draw up the fastening elements
too tight to avoid damaging the thread�
Mounting / dismounting / setting-up of
some elements is the same for all power
tool models, in this case specific models
are not indicated in the illustration�
Additional handle (see fig. 1)
Always use the additional handle 1 when operat-
ing� Additional handle 1 may be positioned in two
positions - vertical (used to store of the power tools)
and horizontal (used for work)�
• Loose wing nut 2 (see fig. 1).
• Move additional handle 1 in horizontal position�
• Tighten wing nut 2�
Mounting / replacement of sanding sheet (see
fig. 2)
Prior to mounting on the sanding sheet 7,
ensure that the given sanding sheet is
suitable for the specific power tool model
(ensure that the adhesive surface, proper
dimensions and dust removal apertures are pres-
ent).
• Position the power tool so that sanding plate 6 is
pointed upwards (see fig. 2).
• In the case of changing the sanding sheet, lift the
brim of used sanding sheet 7 and remove it pulling the
brim further�
• Put new sanding sheet 7 to sanding plate 6� Follow
the rules below:
• the abrasive side of sanding sheet 7 should be on
top (adhesive surface of sanding plate 6 must be at-
tached to the adhesive surface of sanding sheet 7);
• apertures in sanding sheet 7 must match the dust
removal apertures on sanding plate 6�
• Firmly press new sanding sheet 7 against the sur-
face of sanding plate 6�
Attention: when pressing the sheet, en-
sure that the sanding sheet 7 remains
properly placed on sanding plate 6. After
having finally attached the new sanding
sheet 7 the apertures in the sheet and sanding
plate 6 should match.
Mounting / replacement polishing accessories
(see fig. 3-4)
[EX03-125 DV]
Prior to mounting polishing sponge 11
or polishing bonnet 12, ensure that the
given sanding accessories is suitable for
the specific power tool model (ensure
that the accessory comprises adhesive surface
and is of proper dimensions).
• Position the power tool so that sanding plate 6 is
pointed upwards (see fig. 3-4).
• In the case of changing the polishing accessory, lift
the brim of polishing accessory and remove it pulling
the brim further�
English
20