Switching The Product On/Off; First Start-Up - Schwaiger DABWORK2 513 Manual De Instrucciones

USER GUIDE
OPERATION IN DETAIL
Check product and scope of delivery
Risk of damage!
If you open the packaging carelessly with a sharp knife or other pointed objects, the product can be
damaged quickly.
Be very careful when opening it.
1. Remove the product from the packaging.
2. Check if the delivery is complete.
3. Check whether the product or the individual parts show any damage. If this is the case, do not use
the product. Contact the hotline or e-mail address specified in this instruction manual.
Using the product in mains operation
You can use the product directly in mains operation.
NOTE:
RISK OF DAMAGE!
Operate the product only from grounded outlets rated 100 - 240 V AC, 50/60 Hz. If you are unsure of
the power supply at the installation site, check with the relevant power supplier.
1. Place the product on a dry, horizontal, and heat-insensitive surface.
2. Unwrap the power cord connected to the mains connection (13) completely.
3. Insert the mains plug into an easily accessible and properly installed socket outlet (protective con-
tact type F CEE 7/4 or Euro type C CEE 7/17).
Charging the product
If you want to use the product in mobile mode, it is recommended to fully charge the integrated battery
before using the product for the first time.
To do this, proceed as described above under „Using the product in mains operation".
If the product is switched on during the charging process, the symbol
(6) and indicates the charging progress. The charging time is approx. 4.5 hours.
Then disconnect the power plug. The product can now be used as a mobile device and transported using
the carrying handle (18).

Switching the product on/off

• To turn the product on, press the On/Off button (1) on the top of the product.
• To switch the product off, press the On/Off button (1) again.

First start-up

• Switch on the product as described above.
• The LCD display (6) then lights up and the time starts flashing (00:00).
• The product will now perform an automatic station scan in DAB+ mode. Meanwhile, the text
„Scanning" appears in the display and a bar shows the progress of the scan and the number of
stations found.
• After the station scan is completed, the first radio station found in alphanumeric order is played. If no
radio station was found, the text „No DAB Station" appears in the display. In this case, follow the
steps described below in the section „DAB+ radio operation".
22
flashes on the LCD display