60
INSPECTION AND MAINTENANCE
ENOM00324-0
2. Periodic Inspection
It is important to inspect and maintain your outboard motor regularly. At each interval on
the chart below, be sure to perform the indicated servicing.
Maintenance intervals should be determined according to the number of hours or number
of months, whichever comes first.
Description
*1
Carburetor
Fuel filter
Piping/Hoses
Fuel Sys-
tem
*2
Fuel tank
Fuel tank cap
*1
Fuel pump
Spark plug
Ignition
Ignition timing
Starter rope
Starting
Starter motor
System
Battery
Engine oil
*1
Oil filter
Engine
Valve Clearance
*1
Timing belt
Thermostat
Propeller
Gear oil
Lower Unit
Water pump
*1
Power trim & tilt
*1
Warning system
Bolts and Nuts
Sliding and Rotating Parts.
Grease Nipples
Outer Equipment
Anode
Inspection intervals
First 20
Every 50
Every 100
hours of 1
hours of 3
hours of 6
month
months
months
*2
*2
*1
*1
*1
Replace
Replace
*1
*1
Replace
Replace
*1
Every 200
Inspection procedure
hours of 1
year
Strip clean, and adjust.
Check and clean or Replace if necessary.
Check and clean or Replace if necessary.
Clean
Check and clean or Replace if necessary.
Check and clean or Replace if necessary.
Check gaps. Remove carbon deposits or
Replace if necessary.
Check timing.
Check for wear or chafing.
Check for salt deposits and the battery
cable condition.
Check installation, fluid quantity, gravity.
Replace
Replace if necessary.
Replace every 200 hrs or 2 years
Check & adjust
Check and Replace if necessary.
Check and Replace if necessary.
Check for bent blades, damage, wear.
Change or replenish-oil and check for
Replace
water leaks.
Check for wear or damage.
Check & replenish oil, manually operate
Check function
Retighten
Apply and pump in grease.
Check for corrosion.
Check for corrosion and deformation.
Remarks
Entire cartridge
0.8–0.9 mm
(0.031–0.035 in)
Entire cartridge
IN:
0.13–0.17 mm
(0.0051–0.0067 in)
EX:
0.18–0.22 mm
(0.0071–0.0087 in)
370 mL
(12.5 fl.oz.)
Replace impeller
every 12 months.
Replace if neces-
sary.