Installation Variants; Installation And Connection - Oase Aquarius Eco Expert Puesta En Marcha

1 Inlet (suction side)
• With filter cage (3) for pond bottom filtration for submerged installation.
• With hose sleeve for connecting a hose for dry installation.
2 Outlet (pressure side)
• Connection of the return flow to the pond (e.g. via a water course).
3 Filter cage
4 Foot
• With mounting holes for firm installation on the ground, if required.
5 Switching power pack with power cable
• Pump power supply
6 Switch for switching on/off the dynamic function
• Different conveyed volumes are pre-programmed in the pump controls for a dynamic fountain
pattern with changing heights and diameters. When the dynamic function is switched on, the
pump is continuously controlled using these values.
7 Control system connection
• The control unit OASE Eco Control (accessories) is required to operate the pump.
• Alternatively, the pump can be integrated in an OASE Control network.
Hose sleeve ∅ 50 mm
• For information on OASE control, visit www.oase.com.
Hose sleeve ∅ 38 mm
8
9
10 Hose clips for fastening hoses on the hose sleeves.

Installation variants

 A
• Variant (a): Submerged installation of the pump
– The pump is positioned in the pond.
– Water is drawn in via the filter cage (pond bottom filtration).
• Variant (b): Dry installation of the pump
– The pump is installed without a filter cage outside the pond but lower than the water level.
– Water is drawn in via a satellite filter or skimmer.

Installation and connection

The pump can be installed submerged (in water) or dry (outside the water).
The use of the pump is only permitted subject to adherence to the specified water quality.
• Pool water or salt water can impair the appearance of the unit. Such impairments are excluded
from the warranty.
EN
13