POOLSTYLE SSCmini Manual Del Producto página 5

7. Troubleshooting
TROUBLE
Low chlorine
produc�on or
effec�viness
Lack of flow
Displays indicators
POSSIBLE CAUSE
Control unit and/or cell not
connected
Not enough chlorine produced
Blown fuse
pH too high
Scaling on the cell
The gas sensor is not plugged
Salt level too low
Stabilizer too high
Water temperature too low
Closed valves
Pump can't provide enough
water
Dirty filter
Air entering the system
MEANING
Power input not correct
Cable/Cell problem
Low salt level or scaling on
the cell
High salt level
Water temperature out of
range
POSSIBLE SOLUTION
Reconnect the control unit to the mains
power and/or the cell to the control unit
Increase the func�oning hours
Cut the power and replace the fuse
Adjust it between 7.0 and 7.6
See the sec�on 6. Maintenance
opera�ons
Check the men�oned sensor according
to the sec�on 4. Installa�on guide
Add salt to the pool according to the
sec�on 5. Opera�ng instruc�ons
Drain the pool and refill with fresh water
Turn on the heater
Check all the valve posi�ons
Check the correct opera�on of the pump
Clean the filter
Check for any air inlet and water levels
POSIBLE SOLUTION
Check the electrical intake
values
Inspect the cell and or the
cable
Check the salt lever and or
the cell condi�on
Drain some pool water and
refill with fresh water
Adjust water temperature
according to
2. Main features