Remote Control Enable; Messages On The Monitor; Live Mode - urmet domus 1093/064 Guía Rápida

1.3

REMOTE CONTROL ENABLE

The remote control must be enabled to control the device.
Enabling procedure
Press "DEV" on the remote control.
Enter the default address for controlling the DVR using the remote control: press "01" on the remote control.
Press "ENTER" on the remote control.
If successfully enabled, the "STATUS" LED on the front panel of the DVR will light up and turn green.
IMPORTANT NOTE
•
Define a different address for each device if several DVRs are installed, otherwise the remote control will control all
DVRs with the same address at the same time.
Refer to paragraph 5.1.2.2 for how to change the address.
•
Press "DEV" on the remote control for deactivating the remote control: the green "STATUS" LED on the DVR will go
out.
•
You will need to repeat the remote control "enabling/addressing" operation whenever the device is rebooted.
1.4

MESSAGES ON THE MONITOR

The edges of the picture may not be completely visible on some "CRT" monitor models.
1.5

LIVE MODE

The DVR shows the connected video channels after it is switched on: this is called "LIVE" mode.
In this mode, the DVR will not record and will not play recorded sequences back. The date, time, name assigned to the camera
and the camera status bar appear "LIVE" mode. The state icons of all cameras are shown on the status bar. The status icons
show the recording status and alarm status of each camera. Two statuses are shown cyclically. Press "A" on the front panel of
the device to view or hide the camera status bar.
The recording statuses of the camera are shown in the following table.
The alarm statuses of the camera are shown in the following table.
DS1093-013
All manuals and user guides at all-guides.com
RECORDING STATUSES
ICON COLOUR
White
Yellow
Pink
Green
Blue Recording following motion detection
Red Recording following external alarm
ALARM STATUS
ICON COLOUR
White
Yellow
Pink Motion detection or external alarm
Green
Blue
Red
32
STATUS DESCRIPTION
No video signal
Video signal present
Manual recording
Real time recording
STATUS DESCRIPTION
No video signal
Video tampering alarm
No alarm
Motion detection alarm
External alarm