Schedule; Day; All Day - urmet domus 1093/064 Guía Rápida

2.2.1.7

Schedule

Select "Schedule" and press "ENTER" to access the programming menu shown below.
The selected item is highlighted.
Press arrows "◄►" to point the cursor to the various menu items.
Select "CONFIRM" and press "ENTER" to make the changes effective.
Select "CANCEL" and press "ENTER" to cancel the changes.
Press "ESC" to go back by one step.
Press "ESC" several times until the configuration window closes to quit the configuration menu.
IMPORTANT NOTE
•
The device will resume recording only recording tasks programmed in the "Registrazione" menu after a
blackout. Recordings started manually will not be resumed after a blackout.
2.2.1.7.1

Day

This option is used to set and program recording on the selected camera for day of the week.
Use "▲▼" to select.
This option can be used to set up to 4 recording periods for each day of the week with respective event start and end times. The
recording mode can be defined for each period.
2.2.1.7.2

All day

You can also enable recording for the entire selected day.
To enable, select the respective check box using "◄►" and press "ENTER" or "EDIT".
Symbol " " indicates that the whole day recording option is enabled; symbol "×" indicates that it is not.
Check the "All day" option to define the recording mode.
The following recording modes can be selected:
all time
mot det
alarm
mot / alm
mot & alm
command
In this mode, recording is continuous for 24 hours.
IMPORTANT NOTE
If "All Time" is selected, in the event of a blackout or if the device is switched off, the device will automatically resume recording
as soon as network voltage is resumed and the device is switched on again.
In this mode, recording starts as soon as motion is detected.
DS1093-013
All manuals and user guides at all-guides.com
Figure 27: recording programming menu
All time
Motion
40