4�5 Programming And Display Unit - Renfert POWER steamer water softener Manual De Instrucciones

Only use the hoses provided.
Do not use hoses or adapters with conical screw connections. They will damage the connections
en
and cause the warranty to be voided.
When using screw adapters:
Only use matching screw adapters of a suitable length. When screwing on, do not place them axi-
ally on the filter head. Unsuitable adapters can damage the connections and cause the warranty to
be voided.
⇒ Run the flushing hose into a suitable container (e.g., a bucket) or into a
drain�
⇒ Open the purge valve (5) (OPEN).
⇒ Turn on the water supply�
⇒ Insert the filter cartridge into the filter head.
Insert the filter cartridge with its marking at insertion mark A and screw
it in as far as it will go, operating mark B.
♦ Inserting the filter cartridge vents the system and flushes the filter car-
tridge:
- Filter cartridge M: Flush with min� 5 liters of water
- Filter cartridge L:
⇒ Close the purge valve (CLOSE).
⇒ After the initial installation of the filter system, vent and flush the water drain
hose and the POWER steamer 2 with at least 2 liters of water� To do this,
open the service opening on the POWER steamer 2 and run the rinsing
program 3 times (see operating instructions for the POWER steamer 2).
After installing the system and inserting or replacing a filter cartridge,
check all components for leak-tightness. Water must not leak out at any
location.
4.5 Programming and display unit
The programming and display unit can either be attached to the head of the filter unit using the hold-
er (11, Fig. 1) or to a wall using the wall bracket provided (12, Fig. 1).
Attachment to the head using the holder (11, Fig. 1):
⇒ Push the holder onto the head unit until it snaps into place�
⇒ Open the battery compartment and insert batteries, 2 x type AA�
⇒ Pay attention to correct polarity�
⇒ Hang the programming and display unit in the holder�
⇒ Insert the connection cable of the sensor unit into the port on the program-
ming and display unit (20).
Flush with min� 10 liters of water
- 8 -
5
Fig. 5
A
B
Fig. 6
Fig. 7
20
Fig. 8