SOMFY LT 50 CSI RTS Guia De Instalacion página 20

EN
5.3.2 Upper intermediate position - IP1
- Raise the roller shutter/awning to the upper end limit.
- Press the STOP/My button.
- Then simultaneously press the Down and STOP/My
buttons: the roller shutter/awning is lowered.
- Press the STOP/My button when the roller shutter or
awning reaches the required position.
- If necessary, adjust the position of the roller shutter/awning
with the Up and Down buttons.
- Press the STOP/My button until the motor moves for a few
seconds: IP1 intermediate position 1 is programmed.
5.3.3 Lower intermediate position - IP 2
- Lower the roller shutter/awning to the lower end limit.
- Press the STOP/My button.
- Then simultaneously press the Up and STOP/My buttons:
the roller shutter/awning is raised.
- Press the STOP/My button when the roller shutter or
awning reaches the required position.
- If necessary, adjust the position of the roller shutter/awning
with the Up and Down buttons.
- Press the STOP/My button until the motor moves for a few
seconds: IP2 intermediate position 2 is programmed.
5.3.4 Modifying intermediate positions
- Follow the adjustment procedure given in the section
entitled «Intermediate position 1 - IP1» or «Intermediate
position 2 - IP2».
N.B.: the roller shutter/awning must not be in either intermediate
position 1 IP1 or intermediate position 2 IP2.
5.3.5 Deleting an intermediate position
- Press the STOP/My button to find the IP1 or IP2
intermediate position to be deleted.
- Press the STOP/My button until the motor moves for a few
seconds: the intermediate position is deleted.
20
Copyright © 2007-2020 SOMFY ACTIVITÉS SA, Société Anonyme. All rights reserved.
LT 50 CSI
IP1
IP2
IP1
IP2
IP1
IP2