Control Panel - Elmi CM-7S Plus Manual De Usuario

•
Check the rotor and make sure that rotor nut is
securely fastened . Try rotating it by hand . There
should be no noise or obstacles for smooth run-
ning .
•
Check the adapters . All adapters must be equal-
ly positioned inside the brackets .
ATTENTION! If there is any apparent damages or malfunctions, DO NOT TURN ON the centrifuge without consult-
ing a specialist.
ATTENTION! To finish the unpacking of centrifuge, pull the emergency opening lever to the side (as shown on the
figure on page 7) and remove all packaging materials from the rotor bucket.
The centrifuge consists of a stainless steel casing with
nted in it, electric motor and control sys-
rotor mou
tem . Rotor is covered with a self locking transparent
lid . A network switch is mounted in the back of the
Adjustable parameter Parameter value
Tuning keys Settings menu key

Control panel

Centrifuge CM-7S Plus
•
Check the device's surroundings . A safety dis-
tance of 30cm must be observed around the
centrifuge during operation .
•
Check for other signs of damage or malfunc-
tion .
casing . A control panel on the front of the casing
contains the display panel and buttons with the fol-
lowing functions:
Scroll keys
Lid lock indicator (green - opened, red - closed)
Braking level indicator
Display brightness, beeper volume and braking
level can be adjusted in the Settings menu
USER MANUAL
Button to unlock the lid of centri-
fuge .
Button to start the centrifugation
or to end the cycle before the es-
timated time .
5
ENG