Publicidad
Idiomas disponibles
Idiomas disponibles
Performing a Walk Test
The detector automatically enters walk test mode for 10 minutes following tamper
closure. Walk through the entire protected area and observe the LEDs to confirm full
coverage (see LED Status).
Manually initiate a walk test:
From the main menu: 7)Service > 3)Tests > 4)Walk test
(Quick key 7>03>4)
After completing the walk test, set the system to normal operation mode.
MW Range Adjustment
1 Over power
2 Under power
3 Correct adjustment
Anti-Mask Calibration
Following tamper closure, the anti-mask calibration procedure begins (up to 2 minutes). For
successful calibration, make sure that there are no objects near the detector for the duration of the
procedure.
Figure 10
A Detector
B Corridor
1
2
1
2
A
3
10
B
Publicidad
