Risco EL-5835D Instrucciones De Instalación página 7

Deleting a DT Detector from the System
To delete a DT detector from the system:
1. Set the system to Delete mode.
a. Go to the main menu and select [9]>[1]>[1]
(Programming > Devices > Zones).
b. Select a zone and press '√'.
2. Press >12>√.
3. Open the detector and take out the battery.
4. Close and hold the tamper switch.
5. Insert the battery (while the tamper is being pressed).
6. Wait for the the LEDs to stop blinking. Within 5 seconds, open the tamper and close it again.
Step 5: Mount the Detector on the Wall Bracket
Unscrew and separate detector from mounting bracket.
1
Figure 5
7