Publicidad
Idiomas disponibles
Idiomas disponibles
11
11-1
9
Working with the electric
power tool
When working on the machine, observe
all of the safety warnings that are listed
at the start as well as the following rules:
–
Only guide the power tool towards the
workpiece when it is switched on.
Ensure that the clamping lever [1-6] is
–
closed and the eccentric [1-7] is open be
fore starting work.
–
Always secure the workpiece in such a way
that it cannot move during machining.
–
When working, always hold the power tool
with both hands on the handles [2-4]. This
is a prerequisite for precise work and is es
sential for plunge-cutting.
–
When routing, ensure that the power tool's
feed direction is the same as the tool's cut
ting direction, see figure [15].
9.1
Routing
► Set the required routing depth, see sec
tion 8.4.
► Switch on the power tool.
► Open the rotary knob [1-3].
► Push the power tool downwards until it
reaches the limit stop.
► Clamp the power tool in this position by
closing the rotary knob [1-3].
► Plunge into the workpiece slowly and even
ly.
► Perform the routing work.
► Open the rotary knob [1-3].
► Slowly move the power tool upwards until it
reaches the limit stop (lift it out).
► Switch off the power tool.
9.2
Routing with a parallel side fence
The parallel side fence (available as an acces
sory depending on the model) is used in parallel
with the workpiece edge for routing work.
► Clamp the two guide rods [12-4] to the par
allel side fence using the two rotary
knobs [12-2].
► Insert the guide rods into the grooves of the
router table to the required extent and
clamp them using the rotary knob [12-1].
12
11-2
12-1
Fine adjustment
► Open the rotary knob [12-7] to make a fine
adjustment using the adjusting
wheel [12-5].
The scale ring [12-6] has a 0.004" (0.1 mm)
scale for this purpose. If the adjusting
wheel is held, the scale ring can be turned
separately so that it can be set to zero. The
scale [12-3] displays the adjustment in mil
limetres.
► Close the rotary knob [12-7] after making a
fine adjustment.
► Set the two guidance jaws [13-3] so that
they are approx. 7/32" (5 mm) from the cut
ter. To do this, loosen the screws [13-2] and
retighten them after making an adjustment.
► For edge routing only: Push the dust-ex
traction attachment [13-1] from behind un
til it engages on the parallel side fence and
connect an extractor hose with a diameter
of 1-1/16" (27 mm) or 1-7/16" (36 mm) to
the extractor connector [13-4]. Alternative
ly, leave the extractor hose on the power
tool's extractor connector.
2 0
1 0
0
12-2
12-3
English
12-7
12-6
12-5
12-4
15
Publicidad
