Publicidad
Idiomas disponibles
Idiomas disponibles
English
13
13-1
13-2
13-3
9.3
Copy routing
A router with a fitted copying ring (available as
an accessory) should be used for routing work
with templates.
The copying rings can be used with the
base runner supplied as standard. A spe
cial base runner for workpiece support
surface improvement is available as an ac
cessory.
Inserting the copying ring
CAUTION
Risk of accidents
Using a cutter that is too large may damage
the copying ring and cause accidents.
► Ensure that the cutter being used fits
through the opening of the copying ring.
► Lay the power tool on its side on a stable
base.
► Release the lever [14-4].
► Remove the base runner [14-1].
► Release the lever [14-4] again.
► Insert the copying ring[14-3] into the router
table in the correct position.
► Insert the base runner with the tabs [14-2]
into the router table.
► Push the base runner into the router table
until it engages.
Excess Y (figure [15]) of the workpiece to the
template is calculated as follows:
Y = (copying ring diameter - cutter diameter)/2
16
14
13-4
14-1
14-2
14-3
14-4
15
9.4
Edge trimming
The cutters with a ball bearing guide are insert
ed into the power tool for edge trimming. The
power tool is guided in such a way that the ball
bearing guide rolls on the workpiece.
When edge trimming, always use the chip de
flector KSF-OF to improve dust extraction.
9.5
Routing with the FS guide system
The guide system (available as an accessory
depending on the model) makes it easier to
route straight grooves.
► Secure the guide rail to the workpiece using
fastening clamps [16-4].
► Insert the base runner [16-3] for the guide
rail adapter into the router table of the rout
er (see section 9.6). This base runner has a
ridge which adjusts to the height of the
guide rail.
► Clamp the two guide rods [16-6] on the
guide rail adapter using the rotary
knobs [16-5] and [16-9].
► Open the rotary knob [16-1].
► Insert the guide rods [16-6] into the
grooves of the router table.
► Place the router with the guide rail adapter
on the guide rail.
Publicidad
