Setting The Routing Depth - Festool OF 2200 EB-F Instrucciones De Uso Original

English
4
4-1
4-2
4-3
8.4

Setting the routing depth

The routing depth is set in two steps:
Setting the zero point
► Release the clamp lever [5-2] so that the
depth stop [5-3] can move freely.
► Position the router on a level surface (refer­
ence surface). Open the rotary knob [5-1]
and push the power tool downwards until
the cutter sits on the surface.
► Clamp the power tool in this position by
closing the rotary knob [5-1].
► Press the depth stop [5-3] against one of
the three fixed stops of the rotatable step­
ped stop [5-4].
► Push the indicator [5-5] downwards so that
it points to 0" (0 mm) on the scale [5-7].
If the zero position is incorrect, this can be
corrected using the screw [5-6] on the in­
dicator.
A screwdriver can be used to individually adjust
the height of two of the three fixed stops [7] (A
and B).
Fixed stop C has a ridge for rough routing
– see section 8.5.
12
4-4
5
5-1
5-2
5-3
5-4
Specifying the routing depth
► Pull the depth stop [6-6] upwards until the
indicator [6-2] points to the required rout­
ing depth.
► Clamp the depth stop in this position using
the clamp lever [6-3].
► Open the rotary knob [6-1].
The power tool is now in its initial position.
► If necessary, readjust the routing depth by
turning the adjusting wheel [6-8].
Turning the adjusting wheel by a mark
changes the routing depth by 0.004"
(0.1 mm). A full rotation changes the rout­
ing depth by 1/16" (1 mm).
The scale ring [6-7] can be turned sepa­
rately so that it can be set to zero.
The three marks [6-4] on the edge [6-5]
indicate the maximum adjustment range
of the adjusting wheel (3/4" (20 mm)) and
the middle position.
5-7
5-6
5-5