Troubleshooting - Kenwood KMM-BT332 Manual De Instrucciones

References
For /
Each time you press DISP, the display information changes.
• If the information is unavailable or not recorded, "NO TEXT", "NO INFO", or other information
(eg. station name) appears or display will be blank.
Source name Display information: Main display
STANDBY Source name/Clock
RADIO Source name/Clock
For FM Radio Broadcast Data System stations only:
Source name/Clock
Radio text+ Radio text+ song title/Radio text+ artist
Clock back to the beginning
USB For MP3/WMA/AAC/WAV/FLAC files:
Source name/Clock
File name Playing time
iPod USB/iPod BT Source name/Clock
Clock back to the beginning
BT AUDIO Source name/Clock
Clock back to the beginning
AUX Source name/Clock
:
Main display
Clock back to the beginning
Frequency Clock back to the beginning
Station name/Program type Radio text
Frequency
Song title/Artist Album title/Artist
Clock back to the beginning
Song title/Artist Album title/Artist
Song title/Artist Album title/Artist
Clock back to the beginning

Troubleshooting

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
Source cannot be selected.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
Correct characters are not
displayed.
Folder name
Playing time
For
"SET ERROR"/"DEL ERROR"
Playing time
• Radio reception is poor.
• Static noise while listening
to the radio.
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
Send the unit to the nearest service center.
Check the [SOURCE SELECT] setting. (Page 6)
Clean the connectors. (Page 31)
Reset the unit. (Page 4)
• This unit can only display uppercase letters, numbers,
and a limited number of symbols.
• Depending on the display language you have selected
(page 7), some characters may not be displayed
correctly.
Setting/deleting the remote control ID is unsuccessful.
:
Turn the power off, then turn on the power and perform
the operation again. (Page 7)
Connect the antenna firmly.
33
ENGLISH