Initial Settings; Adjusting Initial Settings; Setting The Fm Tuning Step; Switching Auto Pi Seek - Pioneer DEH-1530R Manual De Instrucciones

Section

Initial Settings

08

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1 Press SOURCE and hold until the unit
turns off.
2 Press AUDIO and hold until FM appears
in the display.
Press AUDIO repeatedly to switch between
the following settings:
FM (FM tuning step)A-PI (Auto PI Seek)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down AUDIO until the unit turns off.

Setting the FM tuning step

Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1 Press AUDIO to select FM.
Press AUDIO repeatedly until FM appears in
the display.
2 Press c or d to select the FM tuning
step.
Pressing c or d will switch the FM tuning
step between 50 kHz and 100 kHz while AF or
TA is on. The selected FM tuning step will ap-
pear in the display.
18
En
HHHHHHHHHHHHHH
All manuals and user guides at all-guides.com
Note
The tuning step remains at 50 kHz during manual
tuning.

Switching Auto PI Seek

The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Press AUDIO to select A-PI.
Press AUDIO repeatedly until A-PI appears in
the display.
2 Press a or b to switch the Auto PI seek
on or off.
Pressing a or b will turn A-PI on or off and
that status will be displayed (e.g.,
A-PI :ON).