Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
SOFT-TOUCH CONTROL
NOTES: 1. Each time a key is pressed, a beep is emitted to acknowledge the command. To disable, when the fan and
2. Each time a key is pressed, its backlight turns on. When a function is turned OFF, so does the corresponding
Fan:
When fan is OFF, a key press turns ON the fan to the
last saved speed. If there was no speed saved, the fan
will be set on LOW speed. To change the fan speed,
press the key again until the desired speed is reached
(from LOW, to MEDIUM-LOW, to MEDIUM-HIGH, to
HIGH speed to OFF).
When the fan is ON (no matter the speed level), a long
key press turns the fan OFF and the current fan speed
setting is saved to memory.
Filter Cleaning Reminder
When the user turns the fan OFF, and the fan key
backlight flashes slowly during 30 seconds, then this
means it is time to clean the hood and filters. Refer to
the Maintenance and Cleaning Section on page 18. This
will happen every time the user turns the fan OFF (and
the timer has not been reset).
Once the cleaning is done, at any time during the
30-second signal (and the fan is OFF), a long press
on the fan key will reset the timer and stop the key
backlight flashing.
HEAT SENTRY™
Your unit is equipped with a HEAT SENTRY™ thermostat.
This thermostat is a device that will turn on or speed up the
blower if it senses excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower
up to HIGH speed.
When the temperature level drops to normal, the blower will
return to its original setting.
NOTE: When Heat Sentry is activated, the fan key
backlight flashes slowly and the fan speed cannot
be changed.
The HEAT SENTRY thermostat can start the blower
even if the hood is turned OFF. When this occurs,
it is not possible to turn the blower OFF with the
control. If you must stop the blower, set the main
16
power switch (located behind the filters, on inner
side of the unit faceplate) in OFF position (if it is
possible to do so safely). See inset in FIG. 32.
lights are OFF, press on the Lights key (
press again on the Lights key (
key backlight.
WARNING
!
) for 5 seconds. To put it back, when the fan and lights are OFF,
) for 5 seconds.
Lights:
Press this key to turn ON the lights to the last saved
intensity. If there was no light intensity saved, the lights
will be set on LOW intensity. Press another time to set
the lights to HIGH intensity. Pressing another time after
the HIGH intensity will turn OFF the light.
When the lights are ON, a long press turns the lights
OFF and the current light intensity is saved to memory.
The next time the lights are turned ON, it does so at
the last saved intensity.
Delay OFF:
When fan is ON, press this key to activate the delay
function; the delay off key backlight will be ON for the
duration of the delay (or until cancelled). The fan will
continue to operate for 10 minutes and then, will shut
off automatically.
When the delay mode is active, it is possible to change
the fan speed by pressing the fan key without affecting
the remaining time of the delay.
To cancel the delay function before the end of the
10 minute-cycle, press again on the delay OFF key or
turn OFF fan using fan key.
FIG. 32
Publicidad
