Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARE THE CABINET (
6. Measure the distance between both bottom bracket
edges (F) (FIG. 10). The table below shows the approriate
distance needed.
N
ARROW EDGE
F
From 27-7/8" to < 28-1/16"
If the measured distance needs to be shortened, screw two
no. 8-32 x 1/4" machine screws, in each bottom embossed
cabinet brackets hole; this will slightly bend the bottom part
of the brackets (FIG. 11). Screw both brackets until the
appropriate distance is obtained.
7. There are 3 different sizes of filler included with these units,
designed to fit up to 13-in. depth cabinets. For up to 15-in.
depth cabinets, another set of 4 fillers is available (order
HADTBN30). Choose the filler that fits to cover the back
bottom edge of the cabinet. Use 4 no. 6 x 5/8" truss head
wood screws (included) to mount it (FIG. 12).
CAUTION
Never use an electric screwdriver or drill to screw the
filler to the bottom edge of cabinet; use a standard
screwdriver.
H
ORIZONTAL EXHAUST INSTALLATION ONLY
This powerpack insert is factory shipped to exhaust vertically;
however, it is possible to make it exhaust horizontally (3¼" x 10"
ducting only).
8. Cut the hole for the horizontal exhaust through the back
wall of the cabinet using the dimensions shown. (FIG. 13).
'
)
CONT
D
W
IDE EDGE
F
From 28-1/16" to 28-5/16"
F
Screws in bottom
embossed holes
F
CABINET BACK WALL
5¼"
5¼"
3/4"
CABINET BOTTOM
FIG. 10
FIG. 11
FIG. 12
3½"
9
FIG. 13
Publicidad
