Installation Group I; Installation Group - Mobiclinic LIONFIX Manual De Instrucciones

CAR SEAT LIONFIX
ES EN FR
IT DE PT NL SWE PL DK
5. INSTALLATION GROUP I (9-18 kg)
1. Place the car seat on the seat of the vehicle facing forward. Adjust the tilt so the seat remains upright. Point the two extensions
on the lower back side towards the ISOFIX anchors in the vehicle's seat. Push to connect them until you hear a click. Continue
pushing until the backrest is against the vehicle's seat. Check that the ISOFIX release tabs show the GREEN INDICATOR to ensure
the attachment is secured.
2. Pull the vehicle's seat belt. The diagonal strap must go underneath the headrest. Pass the lap strap underneath both armrests
and fasten the seat belt. Tighten it and make sure the car seat is secure. Place the child on the seat and buckle the harness.
Remember: FOR GROUP I the seat belt must be attached to the car seat through the appropriate slots, NEVER OVER THE BABY.
THE VEHICLE'S SEAT BELT SECURES THE CAR SEAT, NOT THE BABY, THE SEAT HARNESS SERVES THIS FUNCTION IN GROUP I.
ATTENTION: DO NOT USE with a 2-point seat belt. Please install with a 3-point seat belt. Make sure to follow the laws in your
country. The seat belt must be compliant with the ECE R-16 Regulation or an equivalent norm.
ATTENTION: Please use the padding included in the Por favor utilice el reductor que viene con la silla si su bebé tiene un peso
inferior a 15 kg. The padding is used to give extra comfort and security to you baby when they are smaller.
6. INSTALLATION GROUP II (15-22 KG)
Only use the 3-point seat belt. The ISOFIX system can remain anchored to the vehicle if deemed appropriate. The car seat's
harness can be removed for the comfort of the baby..
1. Remove the harness: Press the adjustment tab on the harness and pull with the other hand.
Release the metal buckle of the harness on the back of the seat and remove the connector.
Pull the straps to remove them from the slot. Place the base of the seat upside down and
remove the E-shaped connector from the buckle strap. Keep the parts stored in case they are
needed for future use.
2. When the child is seated, pull the seat belt of the vehicle. Place the diagonal strap under
the headrest and pass the lap strap through the guide on the base and fasten it. Tighten the
seatbelt and make sure the seat is secured.
ATTENTION: DO NOT USE with a 2-point seat belt. Please install with a 3-point seat belt.
Make sure to follow the laws in your country. The seat belt must be compliant with the ECE
R-16 Regulation or an equivalent norm.
16