DeWalt PRESSUREADY DXPW3400PR Manual De Instrucciones página 26

ENgLish
5 Connect spray Wand
to spray gun
Thread the spray wand into
the end of the spray gun.
9 Open Battery housing
Cover
Push the spring lock down to
unlock the cover. Pull cover
up to open.
13 Press the
PREssUREADY
®
sTART/sTOP button
for 2 seconds
The green READY light
will illuminate.
10 Place the fuel
valve lever in the
ON position.

WARNING: This Guide is not a substitute for reading the operator's manual. User must read and understand operator's
manual before using this product.
24
6 Connect QC Nozzles
to spray Wand
Pull quick connect coupler
back and insert nozzle.
Release quick connect
coupler and twist nozzle
to make sure it is secure
in coupler.
10 insert the battery
pack into the battery
housing
Slide battery pack into
housing until it clicks in
place. Close and lock the
battery housing cover.
14 start the Engine:
Depress the spray gun
trigger to start the engine.
Release the spray gun trigger
to stop the engine
Squeeze the spray gun
trigger to restart the engine.
11 Move the Choke to
the CLOsED Position
7 Turn Water Faucet
Completely On
Do not run the unit without
cold water supply connected
and turned on. Use Cold
Water Only.
11 Place the Engine ON/
OFF switch in the ON
position
OFF
ON
ENgiNE
ALTERNATE
MANUAL MODE
sTARTiNg
iNsTRUCTiONs
START WITH THIS STEP
9 AFTER FOLLOWING
STEPS 1–8
12 Pull the Recoil starter
grip
Pull the recoil starter grip to
start the engine.
8 Release Air from
system
Release all air from pump
and high pressure hose
by squeezing the spray
gun trigger until a steady
stream of water is present.
Approximately 30 seconds.
12 Place the fuel
valve lever in the
ON position.
9 Place the Engine ON/
OFF switch in the ON
position
OFF
ON
ENgiNE
13 Move the Choke to
the OPEN Position
Gradually move the choke
to the OPEN position after
engine starts.