Taking A Blood Pressure Measurement - Invacare ISG4002647 Manual Del Propietário

Taking a Blood Pressure
Measurement
•
Wrap the cuff around the wrist (refer to previous page)
•
Sit upright in a chair with feet flat on the floor.
•
Press " " or " " button to select a particular memory zone then
press the "START/STOP" button to start the measurement. The
monitor will automatically inflate to the level that is right for you.
•
When taking repeat measurements, make sure to select the same
memory zone before pressing "START/STOP", so the measurement
is registered to the appropriate memory.
•
If the result of your Systolic or Diastolic rate of your read-
ing result is greater than (not equal to) your set personal-
ized level the DIGIT will flash. In addition the measure-
ment that is out of range, either Systolic or Diastolic, will
flash. If both are out of range both will flash.
If the result of your Systolic or Diastolic rate of your reading result
is equal or less than your set personalized level a SMILING symbol
will show out and flash on screen.
The appearance of this symbol,
irregularity was detected during the measurement. Talking, moving,
shaking or an irregular pulse during the measurement can result in
the appearance of this icon. Usually this is not a cause for concern,
however if the symbol appears often, we recommend you seek med-
ical advice. The device does not replace a cardiac examination, but
serves to detect pulse irregularities at an early stage.
•
To stop a reading in process, press the "START/STOP"
button.
•
Press and hold "Mode" button to check the pre-set per-
sonalized level.
18

Taking a Blood Pressure Measurement

All manuals and user guides at all-guides.com
, signifies that a certain pulse