Switching The Appliance On; Preparing The Door Panels; Loading The Appliance Door; Removing The Installation Support Part - Thermador T18 Serie Instrucciones De Instalación

3.

Switching the appliance ON

To guarantee the accuracy of
and thus the appearance of th
on, the appliance should now be operated.
1. Open the appliance door.
2. Press the POWER button.
3. Press the POWER button again to shut off.
Only for appliances with a water connection:
In order to avoid the risk of damage caused by leaki
water from damage possibly caused to the water pipe
feeding the appliance, keep the shut-off valve clos
4.

Preparing the door panels

Important note:
When performing any work on the door panels, always
observe the following:

Always screw into the best
the door panel.

Never screw into fillers, decorative strips or simi

Select a screw length which is always shorter than
the thickness of the door panel.

To prevent damage, protect surfaces of the door
panels during installation.
The total weight of the door panel must not exceed
following values:

18" Appliance 44 Ibs/20 kg (19 lbs/8.5 kg *)

24" Appliance 55 Ibs/25 kg (32 lbs/14.5 kg *)

30" Appliance 64 Ibs/29 kg
(* Wine unit)
In the case of 30" and 36" wide appliances 2 adjacen
door panels can be attached instead of one large do
These door panels must be connected to a metal stri
on the rear.
This metal strip can be purchased from customer ser
as an optional accessory, see the section on "Requi
accessories and tools/Optional accessories".
Note:
The instructions for carrying out this work step ca n be
found in the separate installa tion instructions for this
accessory.
All manuals and user guides at all-guides.com
the following working steps
e overall kitchen front later
ng
ed.
load-bearing material of
lar.
the
t
or.
p
vice
red
5.

Loading the appliance door

When attaching the door panels, it is recommended t
load the door storage compartments in the appliance
with weights in order to ensure that the gap width
precise as possible.
Recommendations:

18" Appliance: 22 lbs/10 kg

24" Appliance: 33 lbs/15 kg

30" Appliance: 44 lbs/20 kg
6. Removing the installation support
part
Unscrew the positioning aid
Note:
Store the positioning aids, there will be used in a
installation step later.
o
is as
from the appliance door.
n
19