ATOMSTACK Laser Engraver Manual Del Usuario página 15

Setting of engraving/cutting passes, introduction of page key functions in
engraving
1. This is the setting interface of engraving times
Click "+/-" to set the number of times of engraving.
After setting, click the confirm button to enter the
engraving interface.
1 2
3. This is the pause engraving interface.
1.After clicking Pause, the laser will stop the engraving
action and the machine will stop running. Click the resume
engraving button to continue the engraving just now.
2.Click the stop button to end laser engraving and
printing.
2、This is the interface during engraving. This interface can be paused, stopped, and the power
and speed can be adjusted. (Note: There is no return button in this interface. You can only stop
working and return to the engraving preparation interface. After the engraving is completed, it
will return to the engraving preparation interface. The head will move to the starting position of
the last engraving to facilitate repeated engraving of the unified file.
1.Click the "+/-" button to adjust the power and speed, "1%, 10%, 20%" is the percentage value
of the power and speed adjustment, select a different percentage value, and click the "+/-" button
value Also different.
2.Click the pause button to pause the laser engraving operation.
4、This is the interface that pops up when you click to stop engraving.
After clicking the stop button, a confirmation window will pop up, click confirm
to stop engraving and printing, and the interface will return to the boot interface
1
2