ATOMSTACK Laser Engraver Manual Del Usuario página 20

5. Setting engraving parameters
1. Select the engraving file.
Open LaserGRBL software, click "File"> "Open File", then select the graphics you want to engrave, LaserGRBL supports
NC, BMP, JPG, PNG, DXF and other formats.
2.Picture parameters, engraving mode, engraving quality settings
a.LaserGRBL can adjust the sharpness, brightness, contrast, highlight and other attributes of the target picture, when adjusting the
parameters of the picture, the factual effect will be shown in the right preview window, there is no standard here, just adjust the
effect you want.
b. Engraving mode usually choose "line to line tracking" and "1bit dithering", 1bit dithering is more suitable for engraving grayscale
graphics. If you are going to cut, select the vector graphics or centerline engraving mode.
c. Engraving quality essentially refers to the line width of the laser scan, this parameter mainly depends on the size of the laser spot
of the engraving machine, it is recommended to use an engraving quality of 8, The response to laser illumination varies from
different materials, so the exact value depends on the specific engraving material.
d. at the bottom of the preview window, the image can also be rotated, mirror, cut, etc. operations.
Open file