ATOMSTACK Laser Engraver Manual Del Usuario página 29

Part 8: Techniques for using machines
1. The closer the laser is to the table, the less stable the structure will be, try to elevate the laser as far away from the
table as possible when using the laser.
2. Precise positioning of the pattern and the engraved object.
a.Move the laser to the lower left of the frame.
b. Using a ruler and pencil to draw a center point on the engraved object（Picture 1）.
c.The shield must be parallel to the edge of the engraved object（Picture 2）.
Picture 1 draw a center point on the
Picture 2 The shield is parallel to the edge of the
engraved object
engraved object
d.Click on the following two buttons in sequence to move the laser so that the laser point moves to the center of
the engraving. Once the positioning is complete, you can start engraving.
1 2
Picture 3 center point positioning