Cleaning And Maintenance - Gymrex GR-MG 64 Manual De Instrucciones

a) Attach two load holders (11) and securing handles (10) to the supporting
frame. Fix the holders (10, 11) with M12x105 screws, M12 washers and M12
locknuts. Fasten using the procedure described in item a) (see the drawing).
b) Place the footrests (15) on the main frame brackets. For this purpose, place
the sliding sleeves placed on the rotating roller on the inside, between the
mounting plates. Fasten on both sides, on the outside, with M10x20 screws
and M10 washers.
c) Place the reinforcement plate (12) on the main frame brackets, on the
supporting frame side. Fasten with M6 washers and M6x15 screws.
d) Install the chest rest (13) on the main frame. Fasten on the outside with M8
washers and M8x25 screws.
e) Place the the leg rest (14) on the main frame central fastener (14). Attach from
the outside with M12x30 screws. Finally, fix the caps on all fasteners.
All connections of the machine should be fixed and pressed correctly. After
completing the assembly activities, it is allowed to start working with the machine.
Before each use, adjust the footrest height according to your preferences. To adjust
its position, move the footrest up or down.

3.3. Cleaning and maintenance

a) After each cleaning, all components should be well dried before the machine
is used again.
b) Store the machine in a dry and cool place protected from moisture and direct
sunlight.
c) Do not spray the machine with a stream of water and do not immerse it in
water.
d) Regularly inspect the machine for technical failure and damage.
e) Use a soft cloth for cleaning.
f) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or metal
scraper) as these may damage the surface of the machine.
g) Do not clean the machine with acidic substances, medical products, thinners,
fuel, oil or other chemicals as they may damage it.
At the end of its service life, this product must not be disposed of with normal
household waste, but should be taken to a collection point for electric and
electronic machine recycling. This is shown by the symbol placed on the product,
operating manual or the packaging. Materials used in the machine can be reused