Descargar Imprimir esta página

Dacor DHDU990C/DA Serie Instrucciones Para Instalación página 14

Ocultar thumbs Ver también para DHDU990C/DA Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
6. Remove the wood support from the back of the hood
by loosening the 2 screws from the inside.
7.
Line the top of the wood support up with the wood
support location line on the wall, and then center it
on the center line.
8. Locate the marks for the studs on the wood support,
and then draw two vertical lines marking where the
studs intersect with the wood support.
9. Mark the center of each line, remove the wood
support from the wall, and then drill a pilot hole on
the support at each mark.
10. Again, line the top of the wood support up with the
wood support location line, and then center it on the
centerline.
11. Push a pencil point or awl through the holes you just
drilled in the wood support to mark on the wall the
location of the pilot holes for 2 - 6 x 80 mm screws
that will go into the studs.
12. Also mark on the wall the locations of two additional
pilot holes (B) by pushing a pencil point or awl
through pre-drilled holes in the center of the wood
support. These holes are for the supplied 2 - 10 x 60
mm wall anchors. See the diagram below.
1 ³⁄₁₆"
(3 cm)
1 " (2.5 cm)
A. Screw holes
B. Screw holes (already made)
C. Wood Support
14
ENGLISH
A
1 ³⁄₁₆" (3
B
1 " (2.5 cm)
13. Remove the wood support, and then drill four pilot
holes into the wall.
14. Push 2 - 10 x 60 mm of the supplied wall anchors into
the two pilot holes at the center.
15. Fasten the wood support to the wall by screwing 2 - 6
x 80 mm fixing screws through the wood support into
the pilot holes you drilled in the studs.
16. Using the rear installation diagram as a guide (see
page 12), cut the knockout wiring holes in the wall.
17. Screw 2 - 6 x 80 mm screw (mounting screws) into
the holes (B) in the center of the wood support.
Screw them through the support into the anchors
underneath. Leave a ¹⁄₄"(6.4 mm) gap between the
wall and the back of the screw head to slide the hood
into place.
NOTE
Once the hood is mounted you must tighten these
C
screws.
cm)
¹⁄₄" (6.4 mm)
15 ¹⁄₁₆" (38.5 cm)

Publicidad

loading