Publicidad
Idiomas disponibles
Idiomas disponibles
4. ASSEMBLY
4.1 While respecting the previously indicated safety
measurements, make two marks on the wall accor-
ding to measurement "e" indicated in Table 1 and at
a height of 695 mm from the floor (not the skirting
board).
Skirting board
4.2 Drill two 10-mm diameter holes, with a minimum
length of 60 mm at the wall marks.
4.3 Screw the hooks (C) into the two holes, with the
two screws and two plugs (D).
Fig. 6
4.4 Screw the two brackets (A) (or one support,
depending on model) to the rear part of the heater
with the four screws (E) (or two screws, depending
on model).
Note: The two brackets (A) are screwed to the holes
located on the lower rear part, at both ends.
4.5 Hang the heater on the two hooks (C) on the
wall. Ensure that the heater is correctly secured on
both hooks.
Fig. 9
4.6 When the heater is fitted in place, make two mar-
ks on the wall at the two brackets (A) to ensure the
heater is fixed to the wall.
4.7 Drill two 4-mm diameter holes, with a minimum
depth of 25 mm at the two marks on the wall.
4.8 Use the two screws and two plugs B) to comple-
tely secure the heater to the wall.
3. INSTALLING THE FEET:
1. Screw the two feet to the lower rear part of the
heater with the four screws (F).
Fig. 7
Control panel
Pantalla
IR sensor
remote control
prog. button
Increase
Dacrease
Fig. 11
F
Fig. 12
Standby
Confort Mode
Economy Mode
Anti-frost
Fig. 13
www.garsaco.com | 13
EN
Publicidad
